Whelen HA239C User Manual

Browse online or download User Manual for For the car Whelen HA239C. Whelen HA239C User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 2
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
Page 1
®
ENGINEERING COMPANY INC.
51 Winthrop Road,
Chester, Connecticut 06412
Phone: (860) 526-9504
Fax: (860) 526-4078
Internet: www.whelen.com
Sales e-mail: autosale@whelen.com
Canadian Sales e-mail: autocan@whelen.com
Customer Service e-mail: custserv@whelen.com
Automotive: Other
Installation Guide:
Model S30HA*P Strobe Light
and HA239 Strobe Light with cable
©1998 Whelen Engineering Company Inc.
Form No.13409E (041607)
For warranty information regarding this product, visit www.whelen.com/warranty
Safety First
This document provides all the necessary information to allow your Whelen product to be properly and safely installed.
Before beginning the installation and/or operation of your new product, the installation technician and operator must
read this manual completely. Important information is contained herein that could prevent serious injury or damage.
Proper installation of this product requires the installer to have a good understanding of automotive electronics,
systems and procedures.
If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other
vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling
begins. Also de-burr the holes and remove any metal shards or remnants. Install grommets into all wire passage
holes.
If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro®, clean the
mounting surface with a 50/50 mix of isopropyl alcohol and water and dry thoroughly.
Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or
located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a
projectile that could cause serious personal injury or death. Refer to your vehicle owner’s manual for the air bag
deployment area. The User/Installer assumes full responsibility to determine proper mounting location, based on
providing ultimate safety to all passengers inside the vehicle.
For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be made.
The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE (-)
battery post.
If this product uses a remote device to activate or control this product, make sure that this control is located in an
area that allows both the vehicle and the control to be operated safely in any driving condition.
Do not attempt to activate or control this device in a hazardous driving situation.
If this product contains strobe light(s), halogen light(s) or high-intensity LEDs, do not stare directly into these
lights at a close distance. Momentary blindness and/or eye damage could result.
If this product contains strobe light(s), halogen light(s) or high-intensity LEDs, use only soap and water to clean
the lamp lens. Use of other chemicals could result in premature lens cracking (crazing) and discoloration. Lenses
in this condition have significantly reduced effectiveness and should be replaced immediately. Inspect and
operate this product regularly to confirm its proper operation and mounting condition. Do not use a pressure
washer to clean this product.
It is recommended that these instructions be stored in a safe place and referred to when performing maintenance
and/or reinstallation of this product.
FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN DAMAGE TO
THE PRODUCT OR VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS!
Page view 0
1 2

Summary of Contents

Page 1 - Automotive: Other

Page 1®ENGINEERING COMPANY INC.51 Winthrop Road,Chester, Connecticut 06412Phone: (860) 526-9504Fax: (860) 526-4078Internet: www.whelen.comSales e-mail

Page 2 - CABLE INFORMATION

Page 2123AMP 3-PIN CONNECTOR HOUSINGTO POWER SUPPLY.SHIELD WIRE (SEE CABLEINFORMATION).INSERT WIRES WITH PINS ASFOLLOWS: , POSITION 1., POSITION 2., P

Related models: S30HACP | S30HACPD |

Comments to this Manuals

No comments