Whelen DI2S800 User Manual download pdf

Page 1

ENGINEERING COMPANY INC.

51 Winthrop Road,

Chester, Connecticut 06412

Phone: (860) 526-9504

Fax: (860) 526-4078

Internet: www.whelen.com

Sales e-mail: autosale@whelen.com

Canadian Sales e-mail: autocan@whelen.com

Customer Service e-mail: custserv@whelen.com

Automotive: Lightbars

Installation Guide:

Delta™ Independence™ Lightbar

(10/14 Function)

Form No.13913J (060810)

Safety First

This document provides all the necessary information to allow your Whelen product to be properly and safely installed.

Before beginning the installation and/or operation of your new product, the installation technician and operator must

read this manual completely. Important information is contained herein that could prevent serious injury or damage.

• Proper installation of this product requires the installer to have a good understanding of automotive electronics,

systems and procedures.

• If mounting this product requires drilling holes, the installer MUST be sure that no vehicle components or other

vital parts could be damaged by the drilling process. Check both sides of the mounting surface before drilling

begins. Also de-burr any holes and remove any metal shards or remnants. Install grommets into all wire

passage holes.

• If this manual states that this product may be mounted with suction cups, magnets, tape or Velcro®, clean the

mounting surface with a 50/50 mix of isopropyl alcohol and water and dry thoroughly.

• Do not install this product or route any wires in the deployment area of your air bag. Equipment mounted or

located in the air bag deployment area will damage or reduce the effectiveness of the air bag, or become a

projectile that could cause serious personal injury or death. Refer to your vehicle owner’s manual for the air bag

deployment area. The User/Installer assumes full responsibility to determine proper mounting location, based

on providing ultimate safety to all passengers inside the vehicle.

• For this product to operate at optimum efficiency, a good electrical connection to chassis ground must be

made. The recommended procedure requires the product ground wire to be connected directly to the NEGATIVE

(-) battery post.

• If this product uses a remote device to activate or control this product, make sure that this control is located in

an area that allows both the vehicle and the control to be operated safely in any driving condition.

• Do not attempt to activate or control this device in a hazardous driving situation.

• This product contains either strobe light(s), halogen light(s), high-intensity LEDs or a combination of these

lights. Do not stare directly into these lights. Momentary blindness and/or eye damage could result.

• Use only soap and water to clean the outer lens. Use of other chemicals could result in premature lens cracking

(crazing) and discoloration. Lenses in this condition have significantly reduced effectiveness and should be

replaced immediately. Inspect and operate this product regularly to confirm its proper operation and mounting

condition. Do not use a pressure washer to clean this product.

• It is recommended that these instructions be stored in a safe place and referred to when performing

maintenance and/or reinstallation of this product.

• FAILURE TO FOLLOW THESE SAFETY PRECAUTIONS AND INSTRUCTIONS COULD RESULT IN DAMAGE TO

THE PRODUCT OR VEHICLE AND/OR SERIOUS INJURY TO YOU AND YOUR PASSENGERS!

For warranty information regarding this product, visit www.whelen.com/warranty

1 2 3 4 5 6 7 8 9 10

Summary of Contents

Page 1 - Automotive: Lightbars

Page 1®ENGINEERING COMPANY INC.51 Winthrop Road,Chester, Connecticut 06412Phone: (860) 526-9504Fax: (860) 526-4078Internet: www.whelen.comSales e-mail

Page 2 - Strap Mounting:

Page 10NS = Not shown or hidden in parts drawingITEM PART NUMBER DESCRIPTIONQTY QTY QTY QTYQTYQTYQTYQTYQTYQTYNUT 10-24 CAD PLATED WHIZ//NS213547611109

Page 3 - 5" Mounting Foot

Page 2MountingPadAdjustableMountingFootWasherNutMountingPlateStandardMountingFootMountingPadWasherNutMountingPlateBoltBoltIMPORTANT! The lightbar shou

Page 4 - Scan-Lock™ (white-violet)

Page 3MOUNTING FOOTTINNERMANNUTFOOTANCHORPLATESETSCREWPlate slides intolightbar extrusion5" Mounting FootNUTBOLTSPLIT LOCKWASHERMETAL SCREWNOTE:

Page 5 - Available Configurations:

Page 4FRONTFor lightbars withcables exiting theDriver side of theextrusionDrill cable access hole in an areaappropriate for your lightbar(see Warning)

Page 6

Page 502-0363716-00ROTATING REFLECTOR 150-12-H112DELTA STD. ROT CTR/ATOR/.DELTA 2 STD INBD/ ROTATOR .02-0484131-0202-0484131-00SCREW GROMMET #6 #8 FAS

Page 7 - DELTA / LR11 SINGLE OR DUAL

Page 6LOWER LEVEL: OSCILLATORS11414ASS'Y OSCILLATOR DRIVER/SCREW 8 x 3/8" PPHSMS / 410 SS/SCREW GROMMET #6 #8 FASTEX/DELTA ADD 2 OSCILLATORS

Page 8 - EXTRUSION

Page 76NOTE: 5 LIGHT TA SHOWN5243LOWER LEVEL: 5MM LED TRAFFIC ADVISORLOWER LEVEL: TRAFFIC ADVISORTIR6 LED3421765176543246-0743070-0039-0416313-0402-03

Page 9 - FRONT OF LIGHTBAR

Page 8BASEEXTRUSIONBASEEXTRUSIONUpperLower8 X 3/8"PPHSMS410 SS8 X 3/8"PPHSMS410 SSServicing your Lightbar:RTo powerdistributionboardConnect

Page 10 - PART NUMBER DESCRIPTION

Page 924493838534837374736365039395140405232352434273028312630 3135141419153234173333332929FRONT OF LIGHTBAR26121233101112345256716186059

Related models: DI2H800 | DI2H200 |

Comments to this Manuals

No comments

Whelen DI2S800 User Manual

Browse online or download User Manual for For the car Whelen DI2S800. Whelen DI2S800 User Manual

Summary of Contents

Related models: DI2H800 | DI2H200 |

Comments to this Manuals

Related products and manuals for For the car Whelen DI2S800