Whelen 9061211 User Manual download pdf

Page 1

.25

2.01"

1.77"

12.0" ±1.0"

.98 REF

5.61"

AC2

AC3

AC4

AC5

V+

Cathode

Anti-Collision Light

V IN

Anti-Collision Light

FWD & AFT Position Lights

Not Used

20 AWG

18 AWG

20 AWG

CPC 206485-1 22759/43 WIRES

ENGINEERING COMPANY INC.

51 Winthrop Road

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-2009

Internet: www.whelen.com

Sales/Service e-mail: [email protected]

Aviation

Installation Guide:

Aviation model 9061211, 9061212

P/N 01-0790612-11, 01-0790612-12

LED Position / Anti-Collision

Light Assembly

Form No.14603 (062112)

EQUIPMENT LIMITATIONS:

An approved lighting system consists of two lights, one located

on each wingtip. The baseplate must be mounted parallel to

the vertical and horizontal centerlines of the aircraft to project

the patterns properly. A separate flasher assembly, such as

model 7145702, is required for each light assembly.

Certain types of installations may require additional testing.

CONTINUED AIRWORTHINESS:

The forward position light is designed with 4 Green LEDs or 5

Red LEDs. The tail position light is designed with 2 LEDs. The

anti-collision light is designed with 36 LEDs.

If any one bank of LEDs fails, the flasher module should be

checked. If module checks good, replace the lighthead. If any

one LED fails, the unit must be repaired or replaced.

Note: To reduce eye strain, use an optical filter such as dark

glasses or a blue covering dome during LED inspection.

Inspect the lens. Replace if there is excessive scratching,

pitting, discoloration or cracking.

Note: The anti-collision light will automatically shut-off after 9-

10 flashes if a failure is detected by flasher assembly model

7145702.

INSTALLATION PROCEDURES:

The following information is to assist you in installing a Whelen

light system. The installation procedure described in the

following text will be confined to a single light installation, but is

identical for multiple light installations.

1. Choose the appropriate Model 90612( ) light assembly.

2. Using the mounting detail information on page 2, prepare

the aircraft for means to secure the LED light assembly.

Remove any existing mounting adapters.

3. Connect the light inputs according to the chart shown.

Connections to be in accordance with FAA approved

methods.

4. Remove the lens retainers and carefully remove the lens.

Using appropriate hardware, install the light assembly and

insure that all leads are clear of any obstructions. Ty-rap

as required. Secure the light assembly using vibration

resistant threaded fasteners.

5. Carefully reinstall the lens and retainers.

6. Waterproof the lightbase to aircraft. Apply single-part

Silicone (RTV) or equivalent around any open area

where water could get in.

7. Check all avionics systems for interference from this

installation.

8. A flight check should be performed by a properly

certified pilot.

9. Update aircraft records, complete Form 337 and obtain

FAA field approval for installation, as required.

MADE IN THE U.S.A.

The conditions and tests required for TSO approval of this

article are minimum performance standards. It is the

responsibility of those installing this article either on or within

a specific type or class of aircraft to determine that the aircraft

installation conditions are within the TSO standards. TSO

articles must have separate approval for installation in aircraft.

The article may be installed only if performed under 14 CFR

part 43 or the applicable airworthiness requirements.

TSO-C30c

TYPE I, II & III;

APPROVED

TSO-C96a

CLASS I;

APPROVED

1 2

Summary of Contents

Page 1 - Aviation

Page 1.252.01"1.77"12.0" ±1.0".98 REF5.61"123456789AcAC2AC3AC4AC5C6-1V+ACathodeAnti-Collision LightAnti-Collision LightAnti-C

Page 2 - FOR #6, 100° C'SINK

Page 255111111111121112ITEM PART NUMBER DESCRIPTIONASS'Y, GREEN POS. / ANTI-COLLISION LIGHTASS'Y, RED POS. / ANTI-COLLISION LIGHTRETAINER, R

Related models: 9061212 | 9063001 | 9063002 | 9061002 | 7123405 | 7114800 | 7114801 | 7123404 | 7112000 | 7123402 | OR6502RE | 7118400 | 7118401 | 7108040 | 7117001 | 7117002 | 7117007 |

Comments to this Manuals

No comments

Whelen 9061211 User Manual

Browse online or download User Manual for Air equipment Whelen 9061211. Whelen 9061211 User Manual

Summary of Contents

Related models: 9061212 | 9063001 | 9063002 | 9061002 | 7123405 | 7114800 | 7114801 | 7123404 | 7112000 | 7123402 | OR6502RE | 7118400 | 7118401 | 7108040 | 7117001 | 7117002 | 7117007 |

Comments to this Manuals

Related products and manuals for Air equipment Whelen 9061211