Whelen 7108020 User Manual download pdf

Page 1

ENGINEERING COMPANY INC.

51 Winthrop Road

Chester, Connecticut 06412-0684

Phone: (860) 526-9504

Fax: (860) 526-2009

Internet: www.whelen.com

Sales/Service e-mail: [email protected]

Aviation

Installation Guide:

Model 71080( )-series

Model(s) 7108020, 7108030

P/N(s):01-0771080-20

01-0771080-30

LED Flashing Anti-Collision

Light Assembly

Form No.14313D (060314)

OPERATING INSTRUCTIONS:

Operational Voltage: . . . . . . . . . . . 28 VDC nominal

(Operational from 22 VDC to 30 VDC)

Average Input Current: . . . . . . . . . 0.45 Amps

Peak Input Current:. . . . . . . . . . . . 2.0 Amps @ .3 Seconds

The Model 71080 series LED anti-collision light assembly meets the

requirements of FAR 91.205(c)(3).

EQUIPMENT LIMITATIONS: An approved anti-collision light assembly should be

located so that the light will not impair the crew’s vision or detract from the

conspicuity of the position lights. The baseplate must be mounted parallel to the

vertical and horizontal centerlines of the aircraft to project the patterns properly.

Certain types of installations may require additional testing.

CONTINUED AIRWORTHINESS: The 71080 series LED anti-collision light

assembly is designed with 8 vertical columns consisting of 4 LEDs each. Should any

one LED or any vertical column fail, the unit must be repaired or replaced. Inspect

the lens and replace if there is excessive scratching, discoloration or cracking.

NOTE: To reduce eye strain, use an optical filter such as dark glasses or a blue

covering dome during LED inspection.

INSTALLATION PROCEDURES: The following information is to assist in the

installation of a Whelen LED Anti-collision Light System.

1. Using the “suggested mounting hole pattern” prepare the aircraft for

means to secure the LED Anti-collision Light assembly. Remove any

existing mounting adapters.

2. 28 VDC (+) and (-) ground leads equipped with an appropriate sized

breaker to be supplied to the LED Anti-collision Light Assembly System.

Both leads must be connected by an approved FAA connection. Insure

that the wire leads are clear of any obstructions and ty-wrap as required.

CAUTION! Do not touch the LEDs with either fingers or sharp objects. This

could soil and/or damage the LED and effect the optical performance of the

LEDs.

3. Install the light assembly by first removing the lens. Attach the light

assembly to the aircraft mounting holes. Refer to page 2. Reinstall the

lens.

4. All inverted (bottom) mounted units shall require waterproofing of the

flasher base assembly to the aircraft. NOTE: Drill a 1/8” hole in the center

of the lens for bottom mount units.

5. Check all avionics systems for interference from this installation.

6. A flight check should be performed by a properly certified pilot.

7. Update aircraft records, complete Form 337 and obtain FAA field approval

for installation, as required.

MADE IN THE U.S.A.

The conditions and tests required for TSO approval of this article are minimum

performance standards. It is the responsibility of those installing this article either on

or within a specific type or class of aircraft to determine that the aircraft installation

conditions are within the TSO standards. TSO articles must have separate approval

for installation in aircraft. The article may be installed only if performed under 14 CFR

part 43 or the applicable airworthiness requirements.

TSO-C96a

CLASS I, III;

APPROVED

5.55

2.252.70

MFG

LABEL

(-) GROUND

BLACK

AWG

” ±1.0”

(+) 28VDC

WHITE

18AWG

12” ±1.0”

MTG GASKET

(REF)

Model

7108020

3.74

CONNECTOR

MIL-C-38999

SERIES III

20FA98PN

MTG GASKET

(REF)

Ø1.75

2.31

5.79

Model

7108030

1 2

Aviation 1
SUGGESTED MOUNTING PATTERN 2

Summary of Contents

Page 1 - Aviation

Page 1®ENGINEERING COMPANY INC.51 Winthrop RoadChester, Connecticut 06412-0684Phone: (860) 526-9504Fax: (860) 526-2009Internet: www.whelen.comSales/Se

Page 2 - SUGGESTED MOUNTING PATTERN

Page 2(-) GROUNDBLACK” ±1.0”18GA12(+) 28VDCWHITE18GA12” ±1.0”1111484444411ITEM PART NUMBER DESCRIPTIONMODEL 7108020 (EC STYLE)MODEL 7108030 (EC STYLE)

Related models: 7108030

Comments to this Manuals

No comments

Whelen 7108020 User Manual

Browse online or download User Manual for Air equipment Whelen 7108020. Whelen 7108020 User Manual

Summary of Contents

Related models: 7108030

Comments to this Manuals

Related products and manuals for Air equipment Whelen 7108020